Desiccant Filter - Pressure Pot Lid Mount

A desiccant filter is the best way we have found to prevent moisture from reaching your tools and equipment.

This filter is designed to be mounted directly to the pressure pot lid of The ParaBlaster.

After the air travels through the filter/regulator, it is then sent to this desiccant filter. Air enters through the top of the filter, is then sent to the bottom, then it travels back up to the top - through these desiccant beads, then out to your pressure pot. This way, any moisture is removed from the air before it enters the sand system.

When the desiccant is wet, it will turn from blue to pink - showing you that it is removing moisture from the air. The desiccant is re-useable. Simply empty the desiccant onto a cookie sheet and put in the oven at 200 degrees until it turns blue again.

Installation is very quick and easy. Simply remove the IN fitting on your pressure pot and screw this filter in place. Then reconnect the tubing to the lid of the desiccant filter by pressing the tubing into the quick connect fitting.

Includes all the necessary fittings to install.

Replacement desiccant is also available here.

No stand is included with this set up, it is designed to mount directly to the pressure pot lid.

If you would like a desiccant filter on a stand, please see our Desiccant Filter with stand.